📦 Product List

🔧 1 × SW900 Display with rubber bar adaptors & fixing nuts and bolts

🧰 This is the display that comes by default with our 2000W Hub Motor kit.

🎥 There are many YouTube tutorials on how to configure the settings.

ℹ️ Product Information

• ✅ Quality plastic material is lightweight, durable & long service life.
• 📊 LCD displays ride data such as speed, time, temperature.
• 🌙 Backlight for clear visibility in low light.
• 🔗 Suitable for electric bicycle controllers.
• ⚡ Auto-identifies and works with 24V / 36V / 48V / 52V / 60V / 72V.
• 🧠 Compatible with many controller types.
• 🛰️ YF protocol (❌ not for KT).

⚙️ Parameters

• 🖥️ P01 – Display brightness: 1–3 (3 = brightest for sunny days)
• 🛣️ P02 – Units: km/h (0) or mph (1). Set correct wheel size for accuracy.
• 🔋 P03 – System voltage: 24V / 36V / 48V (works up to 72V)
• ⏲️ P04 – Sleep timer: 0–60 min (0 = stays on)
• 🚴 P05 – PAS levels: 0 = 1–3 levels, 1 = 1–5 levels
• 🛞 P06 – Wheel size: set in inches for correct speed
• 🧲 P07 – Speed sensor magnet: factory calibrated; avoid changing
• 🚦 P08 – Speed limit: set to meet local regulations & comfort
• ⚠️ P09 – Zero/Non-Zero start: throttle delay option (safety)
• 🔁 P10 – Drive mode: 0 = PAS only, 1 = throttle only, 2 = PAS + throttle
• 🎚️ P11 – PAS sensitivity: 1–24 (higher = gentler/efficient)
• ⚡ P12 – PAS start strength: 0 (soft) – 5 (strong)
• 🧲 P13 – PAS magnet type: 5 / 8 / 12 (factory set per motor)
• 🔒 P14 – Controller current limit: 1–20A (manufacturer set; don’t change unless needed)

❗ Error Codes